DAVIS Vantage Pro2 Plus, Руководство пользователя

Страница: 21 / 60

Setup Mode
17
reference department of your local library, or refer to internet resources. (See
“Screen 5 and Screen 6: Latitude and Longitude” for a list of web sites.) The more
accurate you are, the better; but a reasonable estimate works too.
1. Press the < and > keys to move from one numeral to another.
2. Press the + and - keys
to adjust a numeral up or down.
3. To switch between feet and meters, press 2ND then press UNITS.
4. If you are below sea level, like in Death Valley or the Salton Sea, first enter the
elevation as a positive number. Then, select the “0” immediately to the left of
the leftmost non-zero digit (the second zero from the left in 0026, for example,
or the first zero from the left in 0207) and press the + and - keys to switch from
a positive to negative elevation.
Note: You can only set the elevation to negative after you have entered a non-zero digit
and when the zero in the position immediately to the left of the left-most non-zero
digit has been selected.
5. Press DONE to move to the next screen.
Screen 11: Wind Cup Size
Vantage Pro2 stations come standard with large wind cups. Switch this setting to
SMALL CUP if you have separately purchased and installed small wind cups.
Switch to OTHER if you are receiving from a Vantage Vue ISS or are using a
third-party anemometer.
Screen 11: Wind Cup Size
1. Press the + and - keys to switch between the LARGE CUP, SMALL CUP, and
OTHER wind cup settings.
2. Press DONE to move to the next screen.
Screen 12: Rain Collector
The tipping bucket in the Vantage Pro2 rain collector has been calibrated at the
factory to measure 0.01''of rain with each tip for US models, or 0.2 mm of rain
with each tip for UK and EU models. The typical user will not need to change this
screen. However, some US users may want to install a metric adapter on their ISS
so that it takes 0.2 mm readings for every tip of the bucket. If a metric adapter
has been installed on your ISS, you should also calibrate your console for metric
measurements using this screen.
Screen 12: Rain Collector Settings