3
O n - B o a r d R e a d e r I n s t a l l a t i o n
SmartCard Desktop Reader
The Desktop Reader is connected to a
computer via a free USB port. The
Desktop Reader works in conjunc-
tion with the FMS software to down-
load DriveRight data via the
SmartCard and to configure all the
SmartCards or DriveRight devices in
the fleet.
Starter Interrupter Kit
The Starter Interrupter Kit is an
optional device installed with the
On-Board Reader that allows
only authenticated users with
validated SmartCards to use and
operate their assigned vehicles.
The kit contains a 12-volt starter
interrupter relay that gets con-
nected to the car’s starter circuit.
If a SmartCard with the assigned Driver ID to the vehicle is inserted into the
On-Board Reader, the vehicle is allowed to start. If an unauthenticated driver
or driver without a SmartCard tries to use the vehicle, the vehicle will not start.
On-Board Reader Installation
Components
The On-Board Reader comes with the components and hardware shown in the
illustration on the next page. Some of the hardware might not be used, depend-
ing on how the On-Board Reader is installed.
Note: Before installing the On-Board Reader, the DriveRight 600 or 600E device, as well as any
other optional accessories, such as the # 8157 GPS module for DriveRight 600 models,
and #8127/8128 GPS module for DriveRight 600E models, should be installed correctly.
See your device’s installation manual for more information.
