Davis Instruments 7747, Руководство по установке

Страница: 3 / 16

Installing the Daytime Fan Kit
3
Put Console in Setup Mode
1. At your Vantage Pro2 console, press and hold DONE and then press the
down arrow ( - ) to put the console in Setup Mode. This prevents the
reception of erroneous data while you are removing the ISS.
Note: If the console acquires erroneous data during the upgrade, refer to “Take the Console
Out of Setup Mode” for instructions on clearing data. Additional information on clear-
ing and setting console data can be found in the
Vantage Pro2 Console Manual .
Take Down the ISS
Please work on your Vantage Pro2 ISS in a safe place. We strongly recom-
mend that you take the ISS down from its sited location before beginning
the upgrade. If you are installing the Daytime Fan Kit on an ISS that has
already been placed into service, you will need to take down the ISS from
its sited location and move it to a convenient and safe place to perform the
installation.
To dissassemble the ISS:
1. Locate the Sensor
Interface Module (SIM)
housing cover on the
side of ISS and open it..
2. Disconnect the Solar
Panel wire on the SIM
cover from the SIM
board by pulling the
Solar Panel connector
3. Pull the foam insert out
of the cable access port
in between the cables
and set the foam insert
aside.
4. Disconnect the ane-
mometer cable from the
sensor connector
labeled WIND and, if
you are using a cabled model, disconnect the console cable from the
SIM.
5. You can now remove the ISS from its mounted position. Move it to a
safe place to install the kit components.
Disassemble the Standard Radiation Shield
Note: We recommend using a workbench or table to perform the following procedures.
1. Open and remove the SIM cover if you have not done so already.
Lift off cover,
unplug solar power
connector
Dettaching the SIM Cover