Maintenance
13
13. Make sure the fan blades rotate in a counter-clockwise direction by
directing the connect SIM cover to sunlight or by shining a bright
incandescent light on the solar panel.
You should hear a slight whir if the fan is running.
Guidelines for Securing Cables
• Secure cables so they will not whip about in the
wind.
• Secure cables to metal poles by using a cable tie
or by wrapping electrical tape around them both.
• Place clips or ties approximately every 3 to 5 feet
(1 to 1.6 m).
• If needed, additional cable ties, cable tie mounts, and other hardware
can be obtained at a hardware or electronics store.
Note:
Do not use metal staples or a staple gun to secure cables. Metal staples—especially
when installed with a staple gun—have a tendency to cut the cables.
Take the Console Out of Setup Mode
1. At your Vantage Pro2 console, press DONE to take the console out of
Setup Mode.
2. Check the console for erroneous rain data and clear if necessary.
To clear erroneous data:
•
Select the weather variable to be cleared.
•
Press and release 2ND, then immediately press and hold CLEAR.
•
The daily rain reading will start blinking.
•
Keep holding CLEAR until the reading changes to zero.
•
Refer to your
Vantage Pro2 Console Manual
for more information
on setting and clearing weather variables.
3. Congratulations! You have completed the upgrade and can now enjoy
your daytime fan-aspirated radiation shield.
Maintenance
• Keep the surfaces of the ISS clean, since the radiation shield and solar
panel are less effective when dirty. Remove dust from the solar panel
and radiation shield with a damp cloth.
• Remove any debris obstructing air flow through the radiation shield
such as leaves, twigs, webs, and nests.
• Do not spray the ISS with insecticides of any kind. Some insecticides
can damage the sensors and even damage the radiation shield.
Cable Clip
Cable Tie
Securing Cables
Содержание 7747
Страница 15: ...Troubleshooting 15...
