Davicom AXON-8A, Быстрый старт

Страница: 15 / 50

15
For the next step, please connect a network (Ethernet) cable between the AXON and your computer. The AXON should
have been previously powered-up as explained in Paragraph 2.
3.
Initial Log-In and Network Setup
The AXON’s factory default IP address is 192.168.1.210.
For the next steps, you will need to temporarily set your computer’s IP address within this range or create an Alias
in your computer’s Network settings. For example, you can use 192.168.1.211.
3.1. Mandatory initial login credential change
The state of California has enacted regulation SB-327 that dictates that all IoT devices that are sold or offered in
the state of California must adhere to specific regulations in regards to passwords configured on the device. All
passwords are required to either be unique or prompt for a password change before the user has access to it.
Upon first log-in, AXON units require that a Supervisor User enter their own password. Default, factory-set
passwords are no longer allowed.
NOTE: This is also the point where you can select whether the AXON will be configured as a Standalone unit for
Web & SNMP or if it will be used as a MODBUS slave unit.
This mode can be changed later, from the Administration/General menu, without doing a factory reset.
After this initial step, the first Login process can take up to 30 seconds while the system configures its setup and
web page views.