background image

2

PLUMBERS NOTE: PUMP POSITION IS IMPORTANT

(Pump must be able to self drain)

Your Davey Spa Bath Pump

Congratulations on your purchase of a quality product from the Davey range of Pool and 

Spa Equipment. You are assured of many years of reliable and efficient performance from 

your Davey Spa Bath Pump backed by Davey’s two year guarantee.
The Davey Spa Bath Pump range has been specially designed to offer optimum 

performance and ample bubbling pressure in spa baths. It should not be used for any other 

purpose without first consulting your Davey Dealer or Davey Customer Service Centre.
The AB and TB models incorporate a thermostatically controlled heater element. The 

heater element maintains the bath water temperature for a long hot bath.
The Celsior range is designed for use in spa baths. They are not recommended for use in 

chemically treated spa pool water.
At Davey we design and build our own electric motors especially for our pumps. The 

matched motor and “pumping end” are designed to provide quiet operation while delivering 

optimum water flow.
Davey’s totally enclosed motor incorporates “auto-start” overload protection with a built-in 

automatic thermostat designed to protect the motor from overheating.  The excess heat 

from the motor is captured by the spa water, ensuring a long hot soak.
Davey Spa Bath Pumps are constructed of durable thermoplastic, eliminating corrosion 

problems and consequent spa bath staining. Specially designed to be self-draining (when 

installed as per instructions), the pump drains after use, preventing the build-up of stale water.

Installation and Operating Instructions

Location

The pump should be located as close to the spa bath as practicable (either internally 

or externally). It is the installer’s/owner’s responsibility to locate the pump such that the 

nameplate can be easily read and it can be readily accessed for service.
It is recommended that the pump is protected from the weather. Enclosures should be 

ventilated to prevent condensation build–up.
Failure to adequately install the Spa Bath Pump as outlined above may result in pump 

damage and/or removal costs not covered by the guarantee.

Содержание Celsior C200A









Отзывы: