Dave Smith Instruments Prophet 08 PE, Руководство по эксплуатации

Страница: 17 / 64

and turn the pot all the way up, it will only go to 90. To get to the maximum
value of 127, you first have to turn down until the value is at the other extreme
and the pot is at the limit of its travel (in this case, 0 and fully counter-
clockwise, respectively).
In Passthru mode, turning the pot has no effect until after the edited value equals
the preset value (that is, until the edited value “passes through” the stored
value).
Jump mode uses an absolute value based upon the position of the pot when
edited: turn a pot and the value jumps immediately from the stored value to the
edited value.
Encoder Mode: Detent, Non-Det –
Optimizes behavior for the type of rotary
encoders (detented or non-detented) on your Prophet ’08. If you’re reading this
in a printed manual that came with a new instrument, you should have a Prophet
’08 PE with detented encoders. Just leave it set to Detent.
If you have updated the OS from an earlier version that did not include this
parameter, you’ll need to determine which hardware version of the Prophet you
have in order to choose the optimum setting. Early standard Prophet ’08s and all
Special Editions originally shipped with non-detented rotary encoders. That is,
all the controls rotate smoothly and without detents or obvious steps. On these
Prophets, this parameter should be set to Non-Det.
If you have a Potentiometer Edition (PE) Prophet, whether purchased that way
or converted from the earlier hardware version, set the parameter to Detent. This
is true even for those PEs that have a mixture of detented and non-detented
encoders. How do you know for certain if your Prophet is a PE? If the filter’s
Frequency control has definite minimum and maximum settings (that is, it
doesn’t just turn endlessly), it is a PE.
Page 12:
LCD Contrast: xxx
MultiMode: xxx
LCD Contrast: 1…100 –
This sets the contrast level for the LCD.
MultiMode: Off, On –
MultiMode allows separate MIDI control of voices 1
through 4 and 5 through 8. The implementation is fairly simple and enables
independent, bi-timbral control of the Prophet.
MultiMode is intended for use with an external sequencer or other MIDI
controller controlling the Prophet ’08. It is meant to be a one-way interface (that
is, from your sequencer to the Prophet).
11