Davco FUEL PRO 483, Техническое руководство

Страница: 13 / 21

FUEL PRO
®
483
TECHNICAL MANUAL
T e c h n o l o g y , L L C
12
DAVCO Technology, LLC P. O. Box 487 Saline, MI 48176 800-328-2611 www.davco.com F1305 REV F
FILTER CHANGE PROCEDURE
1 . Remove the vent cap and open the drain valve to drain
the fuel below the collar level .
2 . Remove the collar (using a DAVCO wrench) then re-
move the clear cover .
3 . Remove the filter, cover and vent cap seals . Dispose of
properly .
4 . Using a clean shop rag, clean the cover, the collar and
threads on the Fuel Pro body .
5 . Install a new filter, cover seal and vent cap seal .
6 . To tighten the collar with the wrench, simultaneously
apply downward pressure to the top of the clear cover
until it is seated on the body of the Fuel Pro and hand
tighten the collar until it no longer spins freely . Torque
the cover assembly by rotating the collar clockwise two
additional ribs using the collar wrench (~18 ft-lbs) .
7 . Prime the unit by filling the clear cover with clean diesel
fuel until it reaches the top of the filter .
8 . Install the vent cap and hand tighten until it clicks
.
Start
the engine and run for one minute . Slowly open the
vent cap and allow the fuel to drop to about one inch
above the collar .
9 . Close the vent cap . Tighten the vent cap by hand until
it clicks . It is normal for the fuel level to vary after the
initial start-up and during engine operation . Filter per-
formance is not affected .
Collar Wrench
P/N 482017
8 in .
Tightening the collar with the wrench:
Simultaneously apply downward pressure to the top of the
clear cover until it is seated on the body of the Fuel Proand
hand tighten the collar until it no longer spins freely . Torque
the cover assembly by rotating the collar clockwise two ad-
ditional ribs using the collar wrench (~18 ft-lbs) .
Note: The DAVCO Fuel Pro collar is designed to be re-
moved with a DAVCO wrench . Collars damaged as a result
of not using the DAVCO wrench will not be covered under
warranty .
Recommended Filters
Brand P/N Micron
Fleetguard FS19915 7