Dato CSST13020, Инструкция по эксплуатации

Страница: 49 / 56

47
NOTICE
Intake filtration equipment supplied from the factory may not be adequate
for extremely dirty applications or some forms of dust or vapors. It is the
customer’s responsibility to provide adequate filtration for those
conditions. Warranty will be voided if inadequate filtration causes a failure.
6.3 FLUID FILTER
The fluid filter is a spin on, full flow unit. Replacement of the filter requires spinning off
the cartridge and replacing it with a new one. The initial filter change should occur after the
first 500 hours of operation. During normal service, the filter cartridge should be replaced
under the following conditions, whichever occurs first:

As indicated by the fluid filter maintenance indicator when the fluid is at normal
operating temperature

Every 2,000 hours

Every fluid change
NOTICE
The fluid filter maintenance indicator may read high upon start up on cool
mornings due to sluggish fluid creating higher than normal differential
pressures. Monitor indicator after the fluid warms up.
6.4 AIR/OIL SEPARATOR
The air/oil separator is using coalescent filter element. Replacement requires unbolting and
lifting the separator cover and replacing it with a new one. The air/oil separator should be
replaced as indicated in the maintenance schedule or as follows:

If excessive fluid carryover is observed.

4,000 hours MAX, or-as indicated by differential pressure indicator.

As indicated by the gauge (if equipped).
Servicing