Datcon DT1400 Series, Руководство по эксплуатации

Страница: 24 / 72

DT1400 xx xx
24
20170920-V0
7. Setting-up
7.1. Typing the code (password) in
The importance of the
code You may enter the menu only after you have typed your
code in. The code is made from 3 numeric characters. This
solution prevents unauthorised persons from changing the
settings of the instrument.
Levels of authorisation •
User level : allows the modification of the most necessary
parameters only. The rest of the menu is not even shown
for users. The user code default factory setting is:
0000 .
•
Supervisor level : allows the modification of all
parameters for the authorised person. The supervisor code
default factory setting is:
1000 .
Typing the code in
1. Press the MENU button. The blinking

mnemonic
shows that the device is asking for the code.
2. Three zeros appear:

. The zero at the left side is
blinking.
•
Pressing the ▲ button you can increase the value of the
blinking number:

,

,

,

,

,

,

,

,

,

, etc.
•
Pressing the ► button to select the next digit.
3. Pressing the ▲ and the ► buttons, type in either the user
code or the supervisor code.
4. Press the
MENU button. If a correct code has been type
in, the mnemonic

(login as a user) or the
mnemonic

(login as a supervisor) is displayed
and stays there for 2.5 seconds; then the first menu item is
shown on the display:

.
5. If an incorrect code has been typing in, the mnemonic

( BAD C ode) is shown on the display and stays
there for 2.5 seconds; then the instrument exits from the
menu, and goes on with the measurement.
Start typing the code in again from Point 1.