Datavideo SE-2000, Инструкция по эксплуатации

Страница: 10 / 40

10
T-Bar
The T-Bar is used to carry out a manual transition such as a wipe, fade,
mix or key. When it has travelled as far as it can go the transition is
complete.
How to calibrate the T-bar:
1. Turn off the SE-2000 power, and push the T-Bar up as far as it can go to its
Top or AIR position then move the T-Bar back down by 2mm.
2. Press and hold in the SET and SUB SOURCE 1 buttons at the same time.
3. Have a colleague turn on the SE-2000 power. When the SET button and
SUB SOURCE 1 buttons are illuminated yellow release both buttons.
4. Push down the T-Bar as far as it can go to its bottom or PVW position and
then move the T-Bar back up by 2mm. Now press the CUT button.
5. Again push the T-Bar up as far as it can go to its Top or AIR position. Now
press the TAKE button.
6. Press SET button again to end the calibration process.
WARNING: If you do not follow the T-Bar calibrating steps correctly the
T-Bar may work incorrectly
Main Source
Used to select which of the source input channels or backgrounds that are
sent to the Main video PROGRAM output. For more information, see
Video
Source (Page 12).
Sub Source
Used to select which of the source input channels or backgrounds will be
transitioned to or used as a sub source in an effect such as PIP.
Headphone
Accepts a stereo mini jack plug for stereo headphones. Used with the Audio
Monitor Button. The headphone volume is adjusted by the rotating Head
phone volume control.
Headphone Volume Control
Controls Headphone volume level.
Use the Headphone section to accurately monitor any of the sources ( CH1,
CH2, CH3, CH4 or “Master” ) output.