Datavideo PTC-305, Инструкция по эксплуатации

Страница: 18 / 136

18
No Function Keys Descriptions
1
Power Button
Power Button
Press this button once to enter Standby Mode, press it
again to enter Normal Mode.
Note: The power consumption in Standby Mode is
approximately half of the power consumption in Normal
Mode.
2
Camera 1-4
Camera 1-4
The Camera 1 to Camera 4 buttons allow you to press the
corresponding number in order for further operation after
the IRID number of the camera is set by the IRID DIP Switch
which is located on the rear panel of your PTC-
305 camera.

If the DIP Switch 1 & 2 are set as (0,0), the camera
IRID number will be 1.

If the DIP Switch 1 & 2 are set as (1,0), the camera
IRID number will be 2.

If the DIP Switch 1 & 2 are set as (0,1), the camera
IRID number will be 3.

If the DIP Switch 1 & 2 are set as (1,1), the camera
IRID number will be 4.
Note: In normal situation, the DIP Switch 3 & 4 must be
“OFF” (set at 0).
PT
Preset1-4 Buttons
The Preset buttons 1, 2, 3, and 4 allow you to set up to 4
camera preset settings.
How to set the Preset: Please adjust your desired camera
parameters and camera lens position in advance. After
that, please press the “STR” button which is located on the
remoter controller. And then please press your desired
Preset Number button (Preset 1 to Preset 4) to set your
setting as a Preset.
How to recall the Preset: Please press the desired “Preset
No.” button (Preset 1 to Preset 4) directly and then the
presaved Preset settings will be recalled successfully.