Datavan ARC Series, Руководство пользователя

Страница: 36 / 42

36
HARDWARE INSTALLATION HARDWARE INSTALLATION
Installing the Identification Reader (Optional)
WARNINN:
Be sure to turn off the power of the Touch Terminal before making any
connection or disconnection.
1. Remove the connectors cover.
(a)
2. Remove the screws securing the dummy cover on the stand arm. (b)
3. Remove the dummy cover.
(c)
4. Remove the stand arm cover. (d)
5. Place the Touch Terminal on a soft and flat surface, with the LCD panel facing down. Then
adjust the stand to full upright position.
6. Remove the five screws securing the bottom of the stand . (e)
7. Carefully flip the Touch Terminal back and remove the top stand cover.
(f)
Tips : To install the reader module to the top stand cover, see the instruction on page 38-39.
7. Firmly connect the identification reader cable to the mainboard connector.
(g)
8. Align and install the identification reader. (f)
9. By holding the top of the identification reader with one hand, carefully flip the Touch Terminal
again, with the LCD panel facing down. Then adjust the stand to full upright position.
10. Secure the bottom of the stand using the five screws . (e)
11. Align the stand arm cover, and then push the stand arm cover inward until it is fully seated.
(d)
12. Install the dummy cover.
(c)
13. Secure the dummy cover to the stand arm using the two screws. (b)
14. Align and install the connectors cover. Make sure to push the connectors cover firmly until it
clicks into place.
(a)