SYNCHRONIZATION 20
• If the correct synchronization signal is received (a signal matching your display’s refresh rate), the
streams will lock after a quick flash of the displays.
• If an incorrect synchronization signal is received, the streams will still be output. However, an error
message will be shown saying that no sync signal was found.
• Successfully locking signals will not yield any message in WATCHOUT.
• If synchronization signal is lost, a warning message will be shown in the production interface.
• If synchronization is reconnected it might take up to 10 seconds for it to lock the streams again.
• If WATCHOUT is set to use the SDI Sync Connector but no synchronization signal is present, the
streams will not be output.
MODE 3: SDI CONNECTOR
The standard SDI connectors can also be used as sync connectors. In order to synchronize your
streams this way, the connector receiving the synchronization signal must be selected in the SDI set-
tings of the WATCHOUT Display (WATCHPOINT) menu.
• Capture source can also be used as a sync signal.
• In case of incorrect synchronization signal or if no signal is present, the streams will be output but
not in synchronization.
• If a machine fails to lock to the synchronization signal all streams in the cluster must be restarted,
even if, for example, two out of three devices successfully locked to the synchronization.
Содержание WATCHPAX 60
Страница 1: ...1 3 WATCHPAX 60 USER S GUIDE ...