120 20195-100 Preliminary
Paragon4 – UHF, 700, & 800MHz User Manual
28
4.
Once the file transfer is complete, cycle the base power and allow the unit to boot. The unit
should return to the state it was in when the update was started.
Note:
After resetting, the PWR LED remaining lit steady amber or red indicates the FTP trans-
fer was not successful or that the firmware is corrupt. Please contact Dataradio system
engineering for assistance.
Figure 17 - Sample FTP program
5.
Verify the integrity of the newly transferred files.
a)
Connect to the base’s IP address using an Internet browser such as IE (5.0 or later) or
Mozilla.
b)
Enter the
user name
and
password
(in the usual manner)
and allow the
Welcome
page to load.
c)
In the left pane, click on
Unit Status
. The
Unit Identification and Status
pane should
display the newly upgraded firmware in its
Banner
(should correspond to the upgrade pack-
age version)
and the
H/W Status
should also show
Ok
.
d)
In the left pane, click on
Maintenance
, then on
Package Control
. Wait a few moments
for the results to display.
5.5.1.1
File Integrity Failure
If the message in the result screen points out that file(s) failed the integrity check, retry the FTP
transfer for the failed files(s) again.
If the problem persists, please have the
Package Control
result screen indications handy and
contact Dataradio system engineering for assistance.