120 20110-100
Gemini/PD Installation Guide
16
This function is frequently used for checking
frequency deviation.
Press the TXON (Modulated) button to be-
gin transmitting a modulated test signal on
the channel selected for 30 seconds or until
pressed again.
The time remaining to test transmit is dis-
played on the status bar.
The functions of all the other buttons are
inoperative during test transmissions.
4.4.4.4 Ping
Button
The Ping function checks connectivity by testing
the ability of Gemini to communicate with the
base station by sending a short transmission
query and receiving a confirming response.
1-
Specify the channel (paragraph 4.4.4.1) and
ping address (paragraph 4.4.4.5)
2-
Press the Ping button to start ping testing.
The time remaining to test transmit is dis-
played on the status bar. The functions of all
the other buttons are inoperative during
pinging.
The program sends a test query and continues
transmitting pings at brief intervals.
As soon as a Ping test signal is returned from
the address selected, the status bar displays:
•
“Ping Successful” and pinging stops.
•
If no ping signal is received after 60 sec-
onds, ping testing stops and the status bar
displays “Ping Failed”.
4.4.4.5 Ping
addresses
Addresses may be entered by typing directly in
the “Ping Address” field in two ways:
1.
Numerically, the valid address range is
1-126.
2.
As an “Alpha-Mapped-Nibble” (AMN) ad-
dress, consisting of upper case letters in the
range A-P. The valid address range is A to
GN.
The base address is usually: 1.
The program may display one of the following
messages on the status bar:
“Ping address is not in AMN or number format”
or
“Ping address is not in the range A – GN”
In either case, check that the address entered is
within the acceptable range, is of a valid format
and correctly typed.