Datapath X4, Руководство пользователя, Страница: 23 / 28

23 18/10/2010
The source of mode selection controls whether the x4 output should take its timing values and
resolution from the preferred mode of the monitor that is connected, or use its internally
programmed ‘default’ mode. Please note that only the internal default timings can be edited
in this dialog.
If Use the Monitors Preferred Mode is selected, but no valid EDID can be read from the
attached monitor, then the x4 firmware will program the output to use the default mode
timings.
The rest of the dialog is identical to that for setting the Input timings, with the exception that
for the output monitors it is possible to select Analog RGB (“VGA”) output as well as DVI.
All modifications to the Output… settings can be save as a .vqs file, removing the
requirement to input the same settings again. To save the settings select the Save…
command in the File menu. To open a saved .vqs file select the Open… command.
Finally there is a Test button which should be used when defining a default mode that you are
not sure the attached monitor can support. In test mode, the output timings are programmed,
but they are not saved to non-volatile memory on the x4 until the
OK button is pressed to
accept the mode.