STEP 5 - CONNECTING A CONTROL SCREEN
Your VSN wall controller is configured to use a control screen connected to the systems internal graphics device
prior to leaving the factory. Connect the control screen to the motherboard graphics output connector on the
rear of the VSN wall controller. A control screen is initially required to set up the system including the operating
system (Windows 10).
STEP 6 - POWERING UP THE SYSTEM
VSN wall controllers are supplied with either a Redundant Power Supply Unit (RPSU) or an ATX power supply.
An RPSU power supply requires two power cables and an ATX supply requires one power cable.
All power cables are supplied with your VSN wall controller.
VGA or DVI
Control Screen
RPSU Power Switch
ATX Power Switch
2
2
1
1
5
Aetria WallControl Quick Start Guide
