MODEL 1980 SERIES PRINTER
OPERATION AND MAINTENANCE
DataMetrics Corporation
12
3.5. External Cable Installation
All external interfaces for the Model 1980 Series printer are located at the rear panel (Figure
3-2). External connector signal assignments are defined in Chapter 1. Perform the
following steps to connect external cabling.
a. Verify that the front panel circuit breaker is in the “off” position.
b. Connect the system ground cable to the ground stud on the rear panel.
c. Install the host computer data interface cable.
d. Connect the power cable to the ac input connector on the rear panel.
Caution
Verify that the ac power source conforms to
the input power configuration defined in
Chapter 1.
3.6. Software Installation
The Okidata C5400n software must be installed before the Model 1980 Series printer can
be used. Information and instructions required for installation and configuration of printer
software is provided in the Okidata C5400n Printer User’s Guide on the supplied CD.
The control panel language can be selected from the System Configuration Menu (Sys
Config Menu) in the menu settings.
3.7. Limited Operation, Storage, and Transportation
If the printer is not operated for more than 1 week, the toner cartridges should be removed
and stored in the supplied black plastic bags. If the printer is to be stored or transported,
the unit should be packaged as originally shipped. The toner/drum cartridges should also be
stored in the black plastic bags in reinstalled into the printer. The printer can be stored or
transported in any manner that is consistent with the environmental conditions identified in
Table 2-3.