Load Ribbon
(perform only if
equipped with the
optional
Thermal Transfer
feature)
a) Push the Printhead Latch down
and raise the Printhead Carrier
Assembly.
Printhead
Latch
Printhead
Carrier
b) Remove and load the Hubs:
Ribbon
Empty Core
Slide a Ribbon onto a Hub and
an Empty Core onto a Hub
Push in and lift
to remove the Hubs
c) Replace the Hubs so that the
ribbon flows as shown below:
Note:
Ensure the inked side of
the ribbon faces the media
and NOT the printhead.
d) Route the ribbon through the printer, as shown below:
Wrap the end of the ribbon
around the Empty Core
and secure it in place
Printer/User
Interface
Normal Mode
F3
F2
F1
Pauses/Un-pauses the printer.
Cancels the current batch of labels.
Press the Pause button to print the next
batch of labels (if any) in the print buffer.
(Normal power-up)
To calibrate media: Press and hold the until one
complete label has been output then release.
Feeds one label and clears fault conditions.
Printing
Configuration
and Test Labels
With the printer ‘On’ and loaded with 4 inch wide media (and ribbon, if needed):
To print the Configuration Label:
Press the
F2
+
F3
buttons simultaneously.
To print the Print Test Label:
Press the
F1
+
F2
buttons simultaneously.
To print the Ethernet/Network Report Label:
Press the
F1
+
F2
+
F3
buttons simultaneously.
Follow and perform the suggested maintenance as detailed in the
Operator’s
Manual
.
For detailed information on the topics referred to in this guide consult the
Operator’s Manual
; for detailed information on custom programming see the
Class Series II Programmer’s Manual
(included on the Accessories CD-Rom).
Contacting Datamax-O’Neil…
Corporate Headquarters
(407) 578-8007
Technical Support
(407) 523-5540
Website: www.datamax-oneil.com
