53
networking. Simply put, it is pure bridging. A simple example would be extending the
range of an existing AP by setting up a 2nd AP and connecting it to the first using LAN-‐
type WDS.
1. Make sure you are using the same Wireless Settings on both routers and not any
type of Wireless Security.
2. Find a drop-‐down selection that has Disabled displayed. Click this and select LAN, do
the same on the other router.
3. On the first router, take the numbers next to Wireless MAC and enter them in to the
second router on the same line that you set to "LAN".
4. Take the Wireless MAC from the second router and enter them on the first router.
5. Check for any typing errors and then click Save Settings.
6. Go to the Wireless Status page. You should see WDS Link and the Wireless MAC of
the other router listed, with a signal reading. If the signal is "0dBm" then there may be
something wrong. Check your antenna connections and configuration settings, and try
again.
7. Once you have a good signal (-‐70dBm to -‐30dBm, -‐70dBm being lowest), you can
change the Internet Connection Type on the Basic Setup page of the second router to
Disabled and set the
Gateway
to the LAN IP Address of the first router. You can now
run normal tests to check if you are connected (like ping).
Lzay WDS:
Default is disabled
.
Note
：
WDS is only available in AP mode. Also Wireless encryption WPA2 and Wireless
network mode B-‐Only are not supported under WDS.
3.1.3.
Services
3.1.3.1.
Services
DHCP Client
Set Vendorclass:
the DHCP server can automatically identify the specific identifier of
the computer running certain operating systems to send, such as the DHCP server can
identify the DHCP client running the operating systerm is Windows 2000 or Windows
Содержание MA100-1010
Страница 20: ... 20 ...
Страница 109: ... 109 ...
