RHINO II/SH BLACKLINE CONFIGURATION
14
RHINO™ II/ SH BLACKLINE
• FN (128)
• KEY (256)
Setting the specific bit to a 1 will lock the respective key. For example, setting HWKey
-
LockFNOff=66 would disable the BL (2) and S2 (64) buttons when the function mode is
not set. Setting HWKeyLockFNOn=256 would disable the KEY (256) button when the
function mode is set.
SCREEN BLANKING
The Rhino II/SH Blackline has the ability to blank the screen when positive voltage is
applied to a designated COM port pin. This is typically used to blank the screen when a
vehicle is in motion, a requirement in some countries. For the Rhino II/SH Blackline, an
external sensor must be used that will either provide a positive voltage when the vehi
-
cle moves, or closes a relay in the same circumstance. If using a relay, then the positive
voltage from pin 9 of the selected COM port should be wired as input to the relay. The
output from the sensor or relay should be wired to pin 1 (DCD) or pin 6 (DSR) of the
selected COM port. The screen blanking cable from Datalogic (p/n 94ACC0157) is wired
to pin 9 (pink) and pin 6 (grey).
Configuration (in \Utilities\UtilConfig.cfg):
Locate (or add) the line ScreenBlankBits=X in the [General] section of the file. X should
be set to the appropriate value from the list:
• 1 – COM1: DCD (pin 1)
• 2 – COM1: DSR (pin 6)
• 4 – COM2: DCD (pin 1)
• 8 – COM2: DSR (pin 6)
Deleting the ScreenBlankBits line from the cfg file will turn off screen blanking.
KEYBOARD CONFIGURATION FILE
The Configuration file is a text file built in sections to provide the definitions for the key
-
board layouts. Comments can be marked at beginning of a line with a semicolon (;).
The configuration is set by commands in the "\Utilities\SoftKeys\SoftKeys.cfg" file.
Section [Common]
In this section general settings will be defined.
Certain settings can be overridden explicitly within the definition sections of the actual
keyboard data for the respective keyboard. These settings are explained separately in a
2nd table.
General Settings
NOTE: Be aware that if you are attempting to control the PWR button, you
can lock the VMC. Disabling the PWR button at the same time you have the
startup mode set to IGN and PWR will block the VMV from being able to be
powered up.
Keyname
Parameter – Info
ImagePath
Directory name for all used Bitmaps within this Cfg. The specified
directory is always searched in the list of the specified CFG file. A
complete path specification is not supported.
Содержание Rhino II/ SH Blackline
Страница 1: ...Rhino II SH Blackline USER S MANUAL Rugged Vehicle Mount Computer...
Страница 50: ......
Страница 51: ......