Scan Mode = Stand Mode
Scan Mode = Trigger Object Sense
Scan Mode = Trigger Single
Scan Mode = Trigger Hold Multiple
Scan Mode = Trigger Pulse Multiple
Scan Mode = Flashing
Scan Mode = Always On
© 2011 - 2014 Datalogic, Inc
820043914 (Rev. B)
May 2014
Stand Mode
No trigger pull is required to read a bar code. Scanning is
turned on automatically when an item is placed in the
reader’s field of view. If the trigger is pulled, the reader
acts as if it in single read mode. Double Read Timeout
prevents undesired multiple reads of the same label
while in this mode.
$CSNRM05
$CSNRM06
Trigger Object Sense
This mode is similar to Stand Mode, except that a
trigger pull is required to activate the decoder.
Trigger Single
This mode is associated with typical handheld reader
operation: when the trigger is pulled, scanning starts
and the product scans until the trigger is released, or a
label is read, or the maximum Scanning Active Time has
elapsed.
$CSNRM00
$CSNRM01
Trigger Hold Multiple
When the trigger is pulled, scanning starts and the
product scans until the trigger is released or Scanning
Active Time has elapsed. Reading a label does not
disable scanning. Double Read Timeout prevents
undesired multiple reads of the same label while in
this mode.
Trigger Pulse Multiple
When the trigger is pulled, continuous scanning is acti-
vated until Scanning Active Time has elapsed or the trig-
ger has been released and pulled again. Double Read
Timeout prevents undesired multiple reads of the same
label while in this mode.
$CSNRM02
$CSNRM03
Flashing
The reader flashes on and off regardless of the trigger
status. Flash rate is controlled by Flash On Time and
Flash Off Time. When Flash is ON the reader reads
continuously. When Flash is OFF scanning is deacti-
vated.
Always On
No trigger pull is required to read a bar code. Scanning is
continually on. Double Read Timeout prevents unde-
sired multiple reads while in this mode.
$CSNRM04
