MATRIX 450™ QUICK REFERENCE GUIDE
22
APPENDIX
X-PRESS™ is the intuitive Human Machine Interface designed to improve ease of
installation and maintenance.
Status information is clearly presented by means of the five colored LEDs, whereas the
single push button gives immediate access to the following relevant functions:
Learn
to self-detect and auto-configure for
reading unknown codes.
Setup
to perform Exposure Time and Gain
calibration.
Focus/Locate
to turn on the Blue Diamonds™
to aid focusing and the laser pointer LEDs to
aid positioning.
Test
with bar graph visualization to check
static reading performance.
In normal operating mode the colors and meaning of the five LEDs are illustrated in the
following table:
READY
green LED indicates the device is ready to operate
GOOD
green LED confirms successful reading
TRIGGER
yellow LED indicates the status of the reading phase
COM
yellow LED indicates active communication on the main serial port*
STATUS
red LED indicates a NO READ result
* When connected to a Fieldbus network through the CBX500, the COM LED is always active, even in
the absence of data transmission, because of polling activity on the Fieldbus network.
During the reader startup (reset or restart phase), all the LEDs blink for one second.
Reader power is indicated by the blue Power LED (located near the Power connector).
Power can be applied to the reader either through the 19-pin male Power connector or the
M12 8-pin male LT-03x Lighting System connector.
The yellow Ethernet Network Presence LED (near the Ethernet connector), indicates
connection to the on-board Ethernet network.
Figure 17 – Power and On-Board Ethernet Network LEDs
On-board Ethernet
Network Presence LED
Power LED
Ethernet MAC Address
Label
Lighting System Signal,
Power Connector
On-board Ethernet
Connector
Power, Serial Host,
I/O Connector
