Datalogic GBT4200-BK-BTK1, Краткое руководство пользователя

Страница: 33 / 56

Programming
QUICK REFERENCE GUIDE
23
PROGRAMMING
The reader is factory-configured with a set of standard
default features. After scanning the interface bar code
from the Interfaces section, select other options and cus-
tomize your reader through use of the programming bar
codes available in the Gryphon™ I GBT/GM4200 PRG.
Check the corresponding features section for your inter-
face, and also the Data Editing and Symbologies chapters
of the PRG.
Using Programming Bar Codes
This manual contains bar codes which allow you to reconfig-
ure your reader. Some programming bar code labels, like the
"Reset Default Settings" on
page 23 , require only the scan of
that single label to enact the change.
Other bar codes require the reader to be placed in Pro-
gramming Mode prior to scanning them. Scan an ENTER/
EXIT bar code once to enter Programming Mode; scan the
desired parameter settings; scan the ENTER/EXIT bar code
again to accept your changes, which exits Programming
Mode and returns the reader to normal operation.
Configure Other Settings
Additional programming barcodes are available in the PRG
to allow customization of programming features. If your
installation requires different programming than the stan-
dard factory default settings, refer to the PRG.
Resetting Product Defaults
If you are not sure what programming options have been set
in your reader, or you have changed some options and want
your custom factory settings restored, scan the bar code
below to reset the reader to its initial configuration. Refer to
the PRG for other options, and a listing of standard factory
settings.
Reset Default Settings
NOTE: Factory defaults are based on the interface
type. Be sure your reader is configured for the
correct interface before scanning this label. See
"Selecting the Interface Type" on
page 14
for
more information.