C-BOX 150
2
2.4.7
OM4000 Jumper Settings
J6
J5
Figure 13 - OM4000 Jumpers
The jumpers allow connection to the EXT TRIG signals on separate spring clamp
terminals for applications which use the OM4000 Oscillating Mirror in Trigger Mode.
They are used together and they have the following significance:
when a jumper is in the J5 position (see Figure above) pin 40 is connected to pin 27
(EXT TRIG+); a jumper in J6 position connects pin 20 to pin 28 (EXT TRIG-).
If the jumpers are removed pin 20 and pin 40 are disconnected.
2.4.8
Configuration Switch And 9-Pin Internal Connector
The 9-pin internal connector may have two different functions according to the
position of the configuration switch.
Figure 14 - Configuration Switch and 9-pin Male Connector
POSITION MODE
Normal Operation
(default): In this position, the C-BOX 150 is in the
normal operating mode. The configuration PC communicates with the
scanner through the 9-pin internal connector and the scanner
auxiliary serial interface. The internal connector pinout is illustrated in
the following table:
14
