© 2015 Datacom Systems Inc
12
VS-10XX-F, VS-11XX-F, VS-12XX-F FASTstart Guide
Step 5:
Set up the IP address, subnet, and gateway on the device to match the network that the
management port is connected to. This can be done by using the commands:
o
SET IP <IP address>
o
SET SUBNET <Subnet mask>
o
SET GATEWAY <Gateway IP address>
o
EXIT
You must enter the “exit” command and log back into the VERSAstream before the changes are
applied.
Step 6:
Once you have logged back in to the device, enter the “show management” command. This
will display setting information regarding the management port. Verify that the settings are correct.
You may choose to configure the VERSAstream using either the serial port or the management port.
All configuration capabilities will be the same for each type.
