Datacolor Spyder5 Elite, Руководство пользователя

Страница: 30 / 64

30
Calibration
If you have selected “Room Light On-Recommended” on the previous screen, a
dialogue will pop up asking you to stay at your computer for the beginning of the
calibration process to adjust your brightness level. The calibration process will stop
about a minute into the process and ask you to adjust your display brightness to the
recommended level. Once you have made an adjustment, either up or down, hit the
“Update” button, it will check the brightness level again to see if you are close to the
recommended setting. When you are within the parameters, you can press the
“Continue” button. It may take a couple of times to get your brightness set properly,
please try to get as close as possible to the target, though it may not fall completely
within the range, that is ok, as long as you are as close as you can be.
This screen shows you where to place the Spyder5 unit for the calibration process.
Remove the cover of the sensor as it is used as a counter-weight so that the unit
remains in place and flat against the screen. We recommend that you slightly tilt
your display back so the unit rests against the monitor without you having to hold it
in place, as any movement can cause a poor calibration.