14
DT-ATSC-QAM-8V2 Manual
RF Output Setup
Use the
[RF Setup Page]
to properly setup each RF output channel.
1.
Enable / Disable RF
output as required.
2.
Enter TS_ID
(Transport Stream ID) value.
3.
Enter
regional name as required
4.
Select
RF type [Normal, Inverted, C.W.]
5.
Select
Channel type [STD, HRC, IRC]
6.
Set
CH/Freq. [CH 2 – CH 135 / Freq. 57MHz ~ 861MHz]
Note:
DT-ATSC-QAM-8V2 is frequency agile
7.
BW:
factory set [6MHz]
8.
Set
attenuation [ 0 ~ -20dB. 1dB Steps]
9.
Select
constellation [64-QAM , 256-QAM]
10.
Select
interleaver – change as required.[Default: I=128, J=1]
11.
Save and Confirm
all changes
Note 1:
Bitrate Mbps shown allows the integrator to quickly review assigned stream
bitrate allocated and Capacity
Note 2:
Bitrate mapping may be required based on the Mbps of the streams/programs
in the RF Out
Note 3:
Use the [Streaming Setup Page] to move program(s) as needed to allow for increased
overhead of required programs
Note 4: Leaving any [RF Output Setup Page] without saving the set parameters will cause
the device to revert to the last saved settings
Содержание DT-ATSC-IP-8V2
Страница 1: ...Manual 8 input ATSC 8VSB QAM B to QAM B Trans Modulator DT ATSC QAM 8V2 User Manual ...
Страница 8: ...8 DT ATSC QAM 8V2 Manual Overview RF Output RF Outputs showing the number of sub streams programs ...
Страница 9: ...9 DT ATSC QAM 8V2 Manual Overview Fan This tab shows fan status and system uptime ...
