Data Translation DT330 Series, Руководство по началу работы

Страница: 30 / 60

Chapter 3
22
Windows NT 4.0
In Windows NT 4.0, the driver is automatically loaded when you
install the DT330 Series driver from the Data Acquisition OMNI CD.
To configure the device driver, perform the following steps:
1. Open the Control Panel.
2. Double-click the Open Layers Control Panel icon.
3. Select the DT330 Series board to configure, then click Advanced.
4. Select the appropriate boxes to enable interrupts for lines (bits) 0
to 7 on digital port D.
5. When you are finished, click Close.
6. If you wish to change the name of the board, click Edit Name and
enter a new name for the board. Otherwise, exit from the Control
Panel.
Once the driver is loaded, perform the steps in Chapter 4 to wire
signals to the board.
Windows 2000
Once you have installed the DT330 Series driver, installed a DT330
Series board, and powered up the host computer, the New Hardware
Found dialog box appears. Perform the following steps to load the
device driver in Windows 2000:
1. Click Next.
2. Click Search for a suitable driver for my device (recommended).
3. Click Specify a location, and click Next.
4. Browse to WinNT/System32/Drivers/DT330.Inf, then click
Open
.
5. Click OK.