Data Translation DT3153, Руководство пользователя

Страница: 110 / 140

Appendix C
94
Windows 98 and Windows Me Procedures
This section describes the following procedures in Windows 98 and
Windows Me:
• Adding a board to the device driver configuration (on this page);
• Modifying the board settings in the device driver configuration
(on page 96 ); and
• Uninstalling the device driver, if necessary (on page 98 ).
Adding a Board to the Device Driver Configuration
To add a new board to the DT3153 Device Driver configuration after
system startup, perform the following steps:
1. If you have not already done so, install the additional board in
your computer following the instructions in the
DT3153 Getting
Started Manual , then power up your computer and any attached
peripherals.
Note: On power-up, the PCI bus takes one available interrupt
from system resources for the DT3153 board. If any devices are
using this interrupt, problems may arise. Verify that no other
devices in your system are using the same interrupt that the
DT3153 board is using and ensure that PCI interrupts are enabled
in your system BIOS.
2. Start Windows 98 or Windows Me.
The Found New Hardware dialog box appears.
3. Click Next .
4. For Windows Me, click Specify the location of the device
(Advanced) , then click Next .