Data Translation DT3130 Series, Руководство по началу работы

Страница: 29 / 54

Installing the Board and Configuring the Device Driver
21
3
3
3
3
3
3
3
3
3
Loading and Configuring the Device
Driver
In Windows 98, Windows Me, and Windows 2000, the driver is
automatically loaded when you install the DT3130 Series driver from
the Imaging OMNI CD. Proceed to configuring the device driver,
described on
page 22 .
In Windows XP, however, you must load the device driver, as
described in the next section, before configuring the device driver.
Loading the Device Driver (Windows XP Only)
Once you have installed the DT3130 Series Device Driver from the
Imaging OMNI CD, installed the board, and powered up the
computer, the
Found New Hardware Wizard message appears. Perform
the following steps to load the device driver:
1. Select the option to Install the software automatically
(Recommended) , then click Next.
2. Click Finish .
The Found New Hardware Wizard message appears for the secondary
device on the DT3130 Series board.
3. Select the option to Install the software automatically
(Recommended) , then click Next.
4. Click Finish .
The Found New Hardware Wizard message appears for the auxiliary
device on the DT3130 Series board.
5. Select the option to Install the software automatically
(Recommended) , then click Next.
6. Click Finish .
7. Proceed to the next section to configure the device driver.