Data I/O FLX500, Поддержание

Страница: 26 / 58


Data I/O

FLX500

Chptr 2
—22—
4. Using the supplied tube with a needle end,
apply the lube to the two holes on the bot-
tom side of the carriage.
5. Since the holes on the top side are not acces-
sible, apply the lube generously to the upper
V-groove with a soft, lint-free cloth. See Fig-
ure 12.
Figure 12—Apply lube to the V-groove on the Y-axis
rail
6. Move the PNP Head assembly along the rail.
Wipe off excess oil.
7. Repeat as needed.
8. Release the Emergency-stop button.
Lubricate the Large Rail as Follows:
1. End the job if one is running. For help end-
ing a job, tap the question mark button [
?
]
for on-screen Help.
2. Push the Emergency-stop button. This
allows moving the gantry by hand.
3. Wipe any dust or dirt off the rail.
NOTE: There is one carriage on the large rail
with a plate on each end of the carriage. Each
plate contains two lubrication holes.
4. Using the supplied tube with a needle end,
apply the lube to the two holes in the plate at
one end of the carriage. See Figure 13. Apply
0.33 cm
3
(.33 milliliters) (.011 oz.) per plate,
with half (0.17cm
3
) applied to each lubrica-
tion hole.