DS065 (5)
2
Q Advanced users:
To remove the existing battery pack:
Remove the lid to the battery compartment by unscrewing the two screws and then lift up from the
screw-hole side.
Lift the battery pack out of the compartment. You will see two wires that go from the battery pack to a
connector. To disconnect, grip the wires at the connector end and pull out in a vertical movement
Note:
The battery pack may have been secured using a double sided pad, if so use a blunt tool to help lever the
pack out.
To fit the new battery pack:
Position a double sided adhesive pad in the bottom of the battery compartment.
Push the plug on the new battery
pack into the connector in the
battery compartment; red wire on
the left and the black wire on the
right. Place the battery pack in its
compartment, positioning the
wires so they lay on top of the
battery.
Screw the lid back into place.
Connect the logger to its
mains power supply and
leave on charge for a
minimum of
12 hours
to
condition the battery pack.
Vu and Vu+ users:
To remove the existing battery pack:
Unscrew the screw and lift off the lid to the
battery compartment. Move the battery pack out
of the way, grip the wires at the connector end
and pull out in a vertical movement.
To fit the new battery pack:
Push the plug on the new battery pack into the
connector in the battery compartment; the black
wire will be on the top and red wire below.
Place the battery pack in its compartment,
positioning the wires so they lay on top of the
battery.
Position the lugs on the compartment lid into
the slots at the bottom of the battery
compartment and screw the lid back into place.
Connect Vu to a USB port and leave on charge
for a minimum of
8 hours
to condition the
battery pack.
Red wire
Black wire
Lug slots