Installing the Drive
14
014–002139
You will need the conversion bracket kit and a medium (#2) Phillips screwdriver. The
conversion bracket kit includes:
Three metal brackets Ċ two side brackets and one end bracket
Screws
If you are installing the drive in a slot in the ECLIPSE MV/3500 computer system
where it will be difficult to connect the computer system's SCSI-bus cable to the
drive, you will need the SCSI-bus adapter cable (005-035005). For information on
the computer system's SCSI bus cable, refer to the computer system documentation.
1.
Attach the side and end brackets to the drive with two screws each, as shown in
Figure 7.
Figure 7 Installing the 3-1/2 Inch to 5-1/4 Inch Conversion Bracket
2.
Install the drive in a 5Ć1/4 inch half height drive slot in the computer or
mass-storage subsystem.
When you have installed the drive in the slot, you are ready to connect the cables to it
as described in the Connecting Cables to the Drive" section.
Connecting Cables to the Disk Drive
To connect the SCSI-bus cable and power cable to the drive, follow the instructions in
either the section for not using an adapter cable or the section for using an adapter
cable, whichever is applicable to your situation.
Connecting Cables When Not Using an Adapter Cable
To connect the cables to the drive when you are not using the SCSI-bus adapter
cable, follow these instructions:
Содержание 6662
Страница 4: ......
Страница 24: ...18 014 002139 ...
