Installation
11
User’s Manual - DSP19.2 Fast Poll Modem
Rack-Mount View
Figure 2-3 shows the rack-mount plug-in module.
Figure 2-3. Rack-Mount Module for the DSP19.2-RM Modem Board
Installation Summary
This section describes the steps for installing the modem.
NOTE:
It is important to follow the steps below to configure the modem’s DIP
switches to match your DTE/RTU interface requirement and the transmission
line characteristics. If you are not certain about your system’s parameters or
the leased-line configuration, please contact your network administrator for
assistance.
1.
Configure the modem using the DIP switches and jumpers. See pages 14 and
19.
2.
Connect to a transmission line. See page 19.
3.
Connect to a voltage source. See page 21.
4.
Connect a DTE device. See page 22.
