using your blade disks
blade and container assembly
Select Blade Disk and appropriate Blade Insert (see next
page for Cutting Guide). Slide Blade Insert into Blade
Disk. *There is no Insert required if using the Shredder
Disk. For detailed instruction, refer to pg.10 of the
Instruction Manual.
To remove Blade Insert, lift Insert up and slide it off of
the Disk. For the Cube / Large Cube / Wavy Disks,
simply slide the Insert out of the Disk.
Inserting
Removing
Make sure to place the Processing Base on
motor unit before placing the blade on base.
When placing Blade onto Processing Base,
ensuring that the tab under the Blade is inserted
into notch in the Motor Base.
NOTE: This notch will be in a different place
each time you stop the Mandoline. Pay careful
attention to make sure that the tab is inserted
into the notch and not in front of or behind
the notch.
When placing the Container under the Motor Base,
making sure to align the sides of the Container
with the slots under the Motor Base. Insert the
Container until the red arrow on the Container
lines up with the red arrow on the underside of
the Motor Base.
NOTE: There is a micro-switch under the Mandoline
that will not be activated if the Container is not
inserted properly.
using your blade disks
blade and container assembly
DEM001H_20190228_QUICKSTARTGUIDE_v2.indd 4-5
3/20/19 10:50 AM
