3
MAINTENANCE & CARE OF YOUR
SYSTEM
Your power unit is warranted against defective materials and
workmanship but not against misuse. There is a service charge for
repairing or replacing damaged or misused components of the
system or for unnecessary service calls.
1. Do not suck up flammable and non-flammable liquids,
chemicals, cement, lime and plaster powders.
2. Do not leave the central vacuum system on unattended.
3. Use only one inlet at a time to maintain maximum suction.
4. Hold the inlet door open for five (5) seconds after removing
the hose. This will make sure that the unit has stopped and
clear any residual dirt out of the pipe system.
5. To empty the dust bucket, undo both clips and lower the
bucket. Remove the cone and empty the bucket.
Replacement is the reverse of this procedure.
6. Each time you empty the bucket or if the suction is
diminished you must clean or replace the filter. To remove
the filter, remove the dust bucket to gain access to the filter.
Unscrew the filter holder anticlockwise and pull the filter
down. Replacement is the reverse of this procedure.
Sponge filters can be washed using cold water only. Allow it
to dry thoroughly before reinstalling.
If Cartridge filters are used, you may attempt to remove
excess dust by shaking and brushing. If this is unsuccessful
and the filter is unserviceable, it should be replaced. Please
note a spare filter is supplied with your new vacuum.
