Manual
Sectional Door Drive
2
DAS
–
Deutsche Antriebs und Steuerungstechnik GmbH
Otto-Hahn-Str. 3
•
48301 Nottuln
•
Germany
GENERAL INFORMATION
The gearmotors to which this instruction booklet refers are designed for operating sectional doors
balanced with springs or weights. If these products are to be used for different applications, it is
recommended to first discuss them with the Manufacturer.
The declaration loses its validity if the gearmotor is modified (e.g. wiring reversal).
SAFETY STANDARDS
• This manual contains important instructions
and warnings regarding safety. Incorrect installation
may cause serious injury. Before commencing work, all sections of the manual
must be read carefully. If in any doubt, suspend installation and call the DAS Support Service for
clarification.
• This man
ual contains important instructions. Keep it for future maintenance work and disposal of
the product.
• Under the latest European legislation, automatic door and gate installations must be compliant
with the standards specified in Directive 2006/42/EC (formerly 98/37/EC) (the Machinery Directive)
and the standards EN 12445, EN 12453, EN 12635 and EN 13241-1 in particular, which enable
conformity of the automated functionality to be de cleared. In the light of the above, all work
involving installation, connection, testing and maintenance of the product must be carried out
exclusively by qualified and competent technicians!
INSTALLATION RULES
• Before commencing the installation, check if the product is suitable for the de sired type of u
se. If it
is not suitable, do not continue with the installation.
• The contents of this manual refer to a standard system.
• All installation and maintenance work must be carried out
with the control unit disconnected from
the electricity supply. If the power disconnection device cannot be seen from where the control unit
is positioned, then before starting work a notice must be attached to the disconnection device
bearing the words “CAUTION! MAINTENANCE IN PROGRESS”.
• The Control unit must be connecte
d to an electricity supply line equipped with protective earthing.
• Handle the product with care during installation, taking care to
avoid crushing, denting or dropping
it, or contact with liquids of any kind. Keep the product away from sources of heat and naked flames.
Failure to observe the above can damage the product and increase the risk of danger or malfunction.
Should this occur, suspend installation work immediately and contact the DAS Support Service.
