4
Ensure your headset is turn on and is properly charged.
Ensure the Bluetooth headset is in pairing mode when you try to pair it with your mobile. If the
headset is left with blue & red LED flashing alternatively but not being paired for over 3 minutes,
the headset will be shut off automatically. You have to turn off the headset then enter the pairing
mode again.
Ensure the Bluetooth dongle or other device is paired with your stereo Bluetooth headset.
Ensure your device is Bluetooth activated. Please refer to your device’s user manual for
instruction.
Ensure the headset is within a maximum 10 meters (about 30 feet.) of your Bluetooth device and
there are no obstructions, such as walls or other electronics devices in between.
If the above suggestions do not solve your problem, please recharge your S810 and Bluetooth audio
device for a while, then start pairing again.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Caution!
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
