Darkly Labs Emblaser Core, Руководство пользователя

Страница: 42 / 49

PAGE 38
USER MANUAL
Darkly Labs
Laser Modes
The Laser can be in any of three modes
Disabled
In this mode, the machine can move normally but the laser will not operate.
Conditions that result in Emblaser disabled mode:
• When first turned on, the Emblaser always defaults to disabled mode.
• The enable button is pressed while laser is enabled.
• The laser shroud is not in place or removed while laser is enabled.
• The stepper motors remain motionless for 60 sec.
• A ‘button stuck’ condition is detected.
Enabled Mode
In this mode, the machine and laser can be operated normally.
There are two possible results when enabling the laser:
• A non-flashing enable LED indicates the laser will be enabled to a non-lasing low power.
In this mode, the laser will be visible, but will below the lasing threshold of the laser diode.
• A flashing enable LED indicates the laser may potentially be enabled at a power level above
the lasing threshold. This could be the result of a previously set laser power or a currently
running cutting job.
How to enter ‘Enabled’ mode
1. Note whether the enable LED is flashing as discussed above.
Enter an ‘M05’ command to ensure the laser is below the lasing threshold when enabled.
2. The laser shroud must be correctly installed.
3. Press and hold down the ‘enable’ button for 2 seconds, until it blinks. Then release the button.
4. The ‘Enabled’ light will now remain lit and the laser is enabled.
Focus Mode
The Laser can be enabled into a limited-power mode to assist in lens focusing. This is the only mode in
which the laser can be operated without the laser shroud being in place.
Important: Extreme care should be taken in this mode and eye protection is mandatory.
How to enter Focus Mode
1. The user and anyone in the vicinity of the machine must be wearing safety eye-wear.
2. Remove laser shroud.
3. Press and hold down the enable button.
After 1 sec the laser will ramp up power to a focusing power.
4. Releasing the button will exit focus mode and disable the laser instantly.
Focus mode will be exited automatically after 1 minute.