DARKLAB PowerBolt II, Руководство пользователя

Страница: 6 / 9

6
USER MANUAL
eGive: Use the up and down buttons to select level. Level 0 = disabled,
Level 1 = Hard, Level 2 = Medium and Level 3 = Soft. When changing eGive
please allow machine to finish sensing needle before using.
Footswitch: On/Off select with Up/Down buttons. The Killswitch will remain
connected until user disconnects it in the PowerBolt II menu.
Timer: Start/Stop select with Up/Down buttons. The timer is 0-24 Hrs in
one minute intervals, once timer is stopped it resets back to zero.
Display: Use Up/Down buttons to select Voltage or Hertz as main power display.
Voltage: Use Up/Down buttons to select increments of 0.1 or 0.5 Volts.
Screen Orientation: Use Up/Down buttons to select left or right hand operation.
Battery Disconnect: Use Up/Down buttons to select Cancel/Off.
To reactivate PowerBolt II, plug into any USB-C
FEATURES
THE POWERBOLT II
OLED Display
Main Power Display
(Hertz or Volts)
Battery charge
Indicator
Bluetooth
Indicator
Secondary Power
Display (Hertz or Volts)
eGive Level Timer
Voltage Up
Power Button
Voltage Down
Battery Charge: 4 bars = 100%, 3 bars = 75%, 2 bars = 50% and 1 bar = 25%.
Single bar will blink to indicate when there is aproximately 5 minutes left of operation.
Note: Screen will switch to sleep mode after 15 seconds when machine not in use.
Press the power button to wake.
Charging: When USB-C is plugged in, screen mode will show battery charging.
For best results, use provided charging cable.
Device Reset: Hold the Up and Down buttons at the same time.
Modes Menu: Hold the power button (center button) for 3 seconds to display built-in menu.
Keep holding power button to cycle through menus. Release to stay on a chosen screen.