Darex XT3000i, Руководство оператора

Страница: 13 / 59

12
To decrease heel relief, rotate clockwise.
To secure the alignment position, tighten
locking lever.
Setting the
drill to the
proper length
3. Holding the chuck in a horizontal position
insert the drill into the appropriate sized
chuck. (Sizes are on the cam).
Allow the drill to protrude approximately 2
inches as shown.
4. Rotate the chuck knob clockwise, which
closes the chuck jaws onto the drill. Then
slightly loosen the chuck jaws by rotating
the chuck knob counterclockwise, about ½
turn. To determine how tightly the drill
should be held during the alignment
process, the drill should slide freely and
drop out when the chuck is held in a
vertical position.
Timing the cutting edge
5. Insert the
chuck and drill
into the
alignment tube.
Align the cam dogs with the slots.
The cam dogs should bottom out against
the slots.
Drill Alignment
2”
118° 135°