NET-AIO11 User’s Manual (Rev 1.0)
-
10-
http://www.daqsystem.com
Read from Lib
board.
It displays that the number of data bytes of read from the library
buffer in application.
10
Buffering WR Pointer
Buffering RD Pointer
It displays a saving pointer of library buffer.
It displays a reading pointer of library buffer.
11
View Scale
A scaling factor displays on the graph.
12
Offset
It is an offset to set the up/down position of graph.
13
Set
View Scale and Offset is applied to the graph.
14
Sample Rate
It selects an Analog data sampling rate.
15
Set
It sets the Sampling rate.
16
0x
It enters the digital output value.
17
Digital Out
It sets the digital output value.
18
Digital In
It confirms the Digital Input value.
Displayed Data, the value of low 0~7 bits are a DIN value, and
8~11 bits value are setup value of DIP switch.
19
IP Address
It enters an IP address to be stored the board.
20
MAC Address
It enters a MAC information to be stored the board.
21
SUB-NET MASK
It enters a MASKING information to be stored the board.
22
GATE WAY
It enters an address of Network Gateway to be stored the board.
23
Port Number
It enters a port numbers to be stored the board.
24
PROGRAM
The section of 20~24 saves in the flash memory.
The stored data will be reflected in the firmware when the board
is reset. Be careful of the confliction to set the same information.
This function is only available with the USB interface, so No. 2)
"USB" selection and this function can use when the No. 6)
“SEL”
run.
25
sec
It enters a delay time of Delay Mode Data collection.
26
Delay + Store
After a delay time of Delay Mode, it executes a data collection.
27
Data READ
It reads a data that is collected in the Delay Mode.
When you run it that is not the end of delay and data collection,
the Beep sound occurs. Otherwise, the data is displayed on the
right side of the graph.
28
RAM LOAD
At right in the path of the editor, USB booting binary loads the
device. First, the running mode should be selected as the USB.
29
FIND
It searches the USB load image.
30
FIND EMIF.BIN
It searches an execution image to be stored in the flash memory.
