DAPAudio WCA Pack, Руководство по эксплуатации продукта, Страница: 7 / 17

6
Receiver
Fig. 2
1) Power switch
Pushing the button switches the transmitter on, the power on (12) LED lights up green. Pushing and
holding the button for three seconds will turn the transmitter off, the power on (12) LED will dim.
2) Reset button
Pushing the reset button, using a pen or small pin, allows you to restore the default factory settings.
3) Power LED
Indicates the status of the transmitter. Lights up continuously when switched on, dims when switched off
and lights up red to indicate a weak battery.
4) AF ou tput
Unbalanced stereo 3,5mm jack. This output provides no real stereo input but splits the mono signal from
the receiver so you can connect receiver to a stereo device using a stereo cable.
5) LED display
The LED displays indicates the channel number during channel setup. If there is no action for 9 seconds,
the display will turn off.
6) Channel button
Push and hold the button for 3 seconds. Now the point in the display will start blinking. Tapping the button
allows you to set the receiving channel. As the button is released for at least 6 seconds, the channel will
be stored. Be aware that when you several WCA Pack systems at the same stage, that the channels
should be separated by at least 4 channels.
7) Pad switch
Allows you to set the level of the AF output (9) at -20dB, -10dB or 0 dB. Use a small screwdriver (included)
to adjust the output attenuation.
8) Belt clip
9) Charge connector