DAPAudio T-5000, Руководство пользователя

Страница: 9 / 18

7
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Install this device on a flat surface.
Cartridge may pick up slight sound pressure or vibrations from the speakers coming along the floor or
though the air resulting in feedback or “howling” sound. Find a location that is very stable and vibration free.
The legs have functions for adjusting the height of the unit itself. Adjust the legs to stabilize the main body
horizontally.
Do not supply power before all components of the system are set up and connected properly.
Connections
1. Connect the power cord to the auxiliary power outlet on the rear panel of your amplifier, receiver or to a
AC outlet.
2. Connect the unit’s output terminals to the PHONO jack of your amplifier or receiver.
Output terminals Mixer (Receiver)
L (White) ---------------------------->L Channel
R (Red) -----------------------------> R Channel
GND (Spade) ---------------------> Ground
NOTE: Be sure to connect the ground terminals firmly to the mixer or receiver. Otherwise hum could be
created.
Operation
1. Turn the On/Off Switch clockwise to turn on the power. The speed indicator and the strobe-illuminator,
which is located beneath the On/Off switch, will light up.
2. Place a record on the slip mat. When playing a 45-rpm record with a large center hole, place the 45-rpm
adapter on the center spindle.
3. Set the speed to match the record.
4. Remove the stylus protector from the Headshell Stylus, release the Tonearm clamp.
5. Set the cueing lever to the up position.
6. Press the Start/Stop button, the turntable platter will start to rotate.
7. Move the tonearm over the desired groove.
8. Set the cueing lever to the down position, the tonearm will descend slowly onto the record and begin
playing.
9. When the record has ended, raise the cueing lever, move the tonearm onto the Tonearm clamp.
10.Press the Start/Stop button to stop the platter from rotating. Turn the On/Off Switch counterclockwise
to turn off the power.
• SUSPEND PLAY - Set the cueing lever to “UP” position during play, the stylus tip of the cartridge will be
lifted from the record.
Changing the Speed
1. As long as the pitch control is in center “detent” click position, the turntable is operated at selected speed.
2. The speed can be increased or decreased by 10% by the pitch control.
An incorrect adjustment done on purpose, can also be used to have the turntable rotate extremely slow or
fast. The strobe dots at the edge of the turntable are used for speed monitoring.