DAPAudio T-5000, Руководство пользователя

Страница: 8 / 18

6
Installation
Remove all packing materials from the Turntable. Check that all foam and plastic padding is removed.
Before use, check for the following parts included in the package with the main unit :Turntable Platter, Slip
mat, Dust Cover, 45-rpm adapter, Counterweight, Headshell.
VERY IMPORTANT!! - Do not forget to attach the rubber belt to the motor for correct operation. After
placing the turntable platter onto the turntable through the center spindle, move one of the large windows on
the Platter to the top right corner. Attach the rubber belt* around the motor
(see fig.3).
(*Rubber belt is already attached to the underside of the Turntable Platter.)
Assembly Turntable :
1. Save packaging for future transporting or shipping.
Fig. 3
2. Set the 45-rpm adapter on the main unit.
3. Set the turntable platter onto the center spindle.
(a) Attach the rubber belt to the motor.
4. Set the slip mat on the platter.
5.
Installation of the cartridge: When installing a cartridge, refer to the operating instructions for that
particular cartridge. During installation, attach the stylus protector to guard the stylus tip from damage.
(a) Connect the lead wires to the cartridge terminals. The terminals of most cartridges are color-coded.
Connect each lead wire to the terminal of the same color.
WHITE (L+)..............Left
BLUE (L-)..............Left channel-
RED (R+)..............Right GREEN (R-)..............Right channel-
(b) Install the cartridge to the headshell and tighten it with screws, provided with the cartridge.
6. Insert the headshell into the front end of the tonearm, then turn the lock nut counterclockwise with the
headshell firmly held horizontally.
7. Slide the counterweight onto the tonearm, twist it lightly and it will screw onto the rear shaft of the
tonearm.
8. Adjustment of horizontal “zero” balance and stylus pressure:
(a) Remove the stylus protector from the headshell, do not touch the stylus tip during the adjustment.
(b) Set the cueing lever to the lowered position.
(c) Release the tonearm clamp and lift the tonearm from the armrest to free it.
(d) Rotate the counterweight, until the tonearm is approximately balanced horizontally (floats freely).
(e) Refasten the tonearm with the tonearm clamp.
(f) Hold the counterweight stationary with one hand and rotate only the stylus-pressure ring, to bring the
number “0” of the ring into alignment with the center line on the tonearm rear shaft.
(g) Rotate the counterweight including the stylus-pressure ring counterclockwise, until the scale shows
the value, corresponding to the pressure of the stylus used.
Should you use a separate stylus, please follow the manufacturer’s instructions.
9. Set the anti-skating control knob to the same value as the stylus pressure.
10. Install the dust cover to the main unit’s dust cover hinges.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.