DAPAudio Odin S-18 Line Array Sub V1, Руководство пользователя

Страница: 17 / 24

16
Odin S-18 Line Array Sub
Product code: D3971
5. Setup and Operation
Safety Instructions for Operation
Attention
This device must be used only for the purposes it is designed for.
This device is designed to be used as a passive line array subwoofer. It is suitable only for indoor use.
Any other use, not mentioned under intended use, is regarded as non-intended and incorrect use.
Attention
Power supply
Before connecting the device to the power supply, make sure that the current, voltage and frequency
match the input voltage, current and frequency specified on the information label on the device.
Setup
You can combine the Odin devices and connect an audio mixer and an amplifier.
To connect the devices, follow the steps below:
Connect the Odin devices and the amplifier. See 5.2.1. Connecting the Amplifier on page 16.
Connect the audio mixer to the amplifier.
Switch on the audio mixer and the amplifier.
After use:
Disconnect the Odin devices.
Switch off the audio mixer and the amplifier.
Connecting the Amplifier
Attention
Speaker load
Before connecting the amplifier to the power supply, make sure that the total load of all connected
speakers is below the maximum rating of the amplifier. If the total load is higher, it may cause damage to
the amplifier and to the speakers.
To determine if the settings are correct:
Add up the wattage settings of all connected speakers.
Compare the value with the maximum rating of the amplifier.
Disconnect speaker(s) as necessary.