DAPAudio ER-216, Руководство по эксплуатации продукта

Страница: 8 / 15

6
Installation
Remove all packing materials from the ER-216. Check that all foam and plastic padding is removed.
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
1) Power output Connector
Plug one end of AC/DC adapter cable to DC input socket in the rear panel of the receiver, and plug
another end into an AC outlet (step 1 of Fig. 1)
2) Audio Output Connector
Connect one end of the AF output cable to the AF output socket in the rear panel, then plug another
end to the “MIC IN” input socket of a mixer or amplifier (Step 2 of Fig. 1)
The receiver equipped with balanced XLR output and unbalanced 6.3mm output, choose the proper
way of use.
3)
Turn the receiver on by pressing the power button in the front panel.
4)
Adjust the AF output level control to select a proper AF signal level.
5) Basic Operation
1. Selecting channel
Press the Up or Down button till the RX1 starts flashing, and again press the Up / Down button to
select a suitable channel from the pre-set 16 channels. Later the RX1 stops flashing, the receiver
will store the channel automatically meanwhile presents the channel no. Repeat the action for
RX2.