DAPAudio entertainer mobile set basic, Руководство по эксплуатации продукта

Страница: 8 / 16

6
Mixer channels
1 / 2 / 3. Equalizer section (HIGH / MID / LOW)
The mixer’s equalizer section allows shaping of the incoming audio signal. Turning
the equalizer controls to the right amplifies the frequency range, turning to the left
attenuates the signal. Minor changes to the equalizer controls usually produce the
best results. Try to avoid excessive enhancement of the mid band.
4. Eff/Aux control
This control lets you route the corresponding input signal to the integrated digital
effect unit at variable levels. In this way assigning special effects to musical
instruments or vocals is fairly simple. When making an effect-mix, it’s advisable to
start with all FX- controls set to their center position. You can further increase or
reduce the effect’s intensity, depending on your personal preferences.
5. Pan control
By using the panorama control you can change the input signal’s position within
the stereo image. When the panorama control is set to center position, the audio
signal is equal for both the left and right output.
6. Peak/signal LED
Lights green if an audio signal is present, lights red if the channel clips.
7. Level control
Adjust the volume level of each channel. Rotating the control clockwise increases
the volume of each channel, counterclockwise decreases the output volume.
You can adjust this volume control knob after the main volume has been set up.
8. EFF/aux return control
Controls the volume level for the Aux return (33) input.
Note: If the Main stereo/monitor switch (12) is set in main monitor position, the aux
signal will be routed to the Main output only and will not be routed to the monitor
output.
9. MP-3 level control
Controls the level of the USB- MP3 player.
Note: If the Main stereo/monitor switch (12) is set in main monitor position, the MP3
signal will be routed to the Main output only and will not be routed to the monitor
output.
Master section
10. 7-Band equalizer
All 7 frequency bands (60Hz, 160Hz, 400Hz, 1KHz, 2,5KHz, 6KHz, 16 KHz) provide a ±12dB
amplification/attenuation. You can change the overall sound, thus meeting your requirements for
different locations. If you want your sound to have more bass, you have to boost the low frequency
range, using the 60Hz or the 160Hz controls. If you experience too much bass, lower the levels of the
60Hz and 160HZ controls. If the mid-range sounds a bit nasal, try attenuating the 1KHz, 2,5KHz and
6Khz controls by some decibels. If you want to have a clear and highly intelligible sound, you should
increase the level setting of the 6kHz or 16kHz band a bit. When using the equalizer, less attenuation is
better than a great change of the control settings.
11. EQ On/Off switch
You can press the EQ button to bypass the equalizer.